Orange pi 5 plus

Orange Pi 5 Plus (4GB/8GB/16GB)
Wiki for Orange Pi 5 Plus.
Orange pi 5 plus vs Orange pi 5. Orange pi 5 uses RK3588S & Gigabit ethernet but Orange Pi 5 plus uses RK3588 & 2.5G ethernet.
RK3588 vs RK3588S

Booting from NVME

The instruction on wiki How to burn Linux image to SPIFlash+NVMe SSD->The method of using the dd command to burn works when I tested on Debian 11 KDE Plasma installed on a SD card.
1. burn the u-boot image into the SPI Flash
```
sudo nand-sata-install
# select 7 Install/Update ther bootloader on SPI Flash
```
2. use 'dd' to clear the NVMe SSD & burn the linux image to NVME SSD
The NVME speed is 2046 MB/s by using the command sudo hdparm -t --direct /dev/nvme0n1p2 . The NVME is inland TN450 (500GB).
What is /dev/mtdblock0
- In the context of the Orange Pi 5 Plus, the /dev/mtdblock0 partition is used to store the bootloader.
- Booting directly from a USB or NVMe requires flashing U-Boot to the SPI.
- How to boot Orange pi 5 from SATA m.2 SSD (for Orange pi OS and Armbian)

If you want to boot from eMMC on the Orange Pi 5 Plus, you would need to clear the /dev/mtdblock0 partition. This is because the /dev/mtdblock0 partition typically contains the bootloader, and clearing it allows you to install a new bootloader that can boot from the eMMC.
- Here is a general guide on how you can do this: Boot Armbian from an SD card.
- Clear the SPI flash memory by running the following command in the terminal: sudo dd if=/dev/zero of=/dev/mtdblock0 bs=1M count=1

Need help with Orange Pi 5 Plus emmc
Need help with orange pi 5 plus emmc boot. Use Josha's image. No Maskrom. rkdeveloptool & MiniLoaderAll.bin
NEW Orange Pi 5B. Installing Custom Ubuntu to eMMC drive. Windows OS is required. RKDevTool is needed. 1. install a driver (DriverAssistant). Run DriverInstall.exe, 2. Run RKDevTool.exe. Full list of videos from leepsvideo.
Armbian Orangepi 5B can not boot from emmc
Using Windows VM on a Linux
RKDevTool/rkdeveloptool by radxa.com.