Udoo: Difference between revisions
Jump to navigation
Jump to search
| Line 20: | Line 20: | ||
On Udoo itself, I can use '''dmesg | grep ttymxc3''' to double check the device is attached. | On Udoo itself, I can use '''dmesg | grep ttymxc3''' to double check the device is attached. | ||
On an external computer, I try to use '''dmesg | grep cp210x''' to check the device. The obstacle is the device is not found in Arduino IDE (No device found on ttyUSB0). If I try to follow 'Serial Driver' part to download and run 'make' , I will get an error | On an external computer (unplug J18 jumper, remove microSD card), I try to use '''dmesg | grep cp210x''' to check the device. The obstacle is the device is not found in Arduino IDE (No device found on ttyUSB0). If I try to follow 'Serial Driver' part to download and run 'make' , I will get an error | ||
<pre> | <pre> | ||
Linux_3.x.x_VCP_Driver_Source/cp210x.c:164:12: Error： 'usb_serial_probe' undeclared here (not in a function) | Linux_3.x.x_VCP_Driver_Source/cp210x.c:164:12: Error： 'usb_serial_probe' undeclared here (not in a function) | ||
Linux_3.x.x_VCP_Driver_Source/cp210x.c:165:16: Error : 'usb_serial_disconnect' undeclared here (not in a function) | Linux_3.x.x_VCP_Driver_Source/cp210x.c:165:16: Error : 'usb_serial_disconnect' undeclared here (not in a function) | ||
</pre> | </pre> | ||
Revision as of 14:00, 20 October 2013
Documentation
- Starting manual
- Mechanical Specs
- Schematics
- Pinout explained
Download
- SD Image and instruction to burn the image to microSD card; like
sudo umount /dev/sdc1 sudo dd bs=1M if=~/Downloads/udoo_dual_ubuntu_1.2.img of=/dev/sdc sudo sync sudo umount /media/<sd_label>
Arduino Programming
http://www.elinux.org/UDOO_programming_the_embedded_Arduino_microcontroller
On Udoo itself, I can use dmesg | grep ttymxc3 to double check the device is attached.
On an external computer (unplug J18 jumper, remove microSD card), I try to use dmesg | grep cp210x to check the device. The obstacle is the device is not found in Arduino IDE (No device found on ttyUSB0). If I try to follow 'Serial Driver' part to download and run 'make' , I will get an error
Linux_3.x.x_VCP_Driver_Source/cp210x.c:164:12: Error： 'usb_serial_probe' undeclared here (not in a function) Linux_3.x.x_VCP_Driver_Source/cp210x.c:165:16: Error : 'usb_serial_disconnect' undeclared here (not in a function)