Udoo: Difference between revisions
No edit summary |
|||
| Line 35: | Line 35: | ||
Linux_3.x.x_VCP_Driver_Source/cp210x.c:165:16: Error : 'usb_serial_disconnect' undeclared here (not in a function) | Linux_3.x.x_VCP_Driver_Source/cp210x.c:165:16: Error : 'usb_serial_disconnect' undeclared here (not in a function) | ||
</pre> | </pre> | ||
= Serial port monitor = | |||
On Linux, I can use minicom program to monitor serial port. | |||
Use '''sudo minicom -s''' to configure minicom. Make sure the port is what we want. For example, '''/dev/ttyS0''' when we use UDOO' ubuntu and '''dev/ttyUSB0''' when we use external PC. The baud rate is set to 9600 8N1 and that 'Hardware flow control' is set to 'no'. Once we are done with the settings, use 'Save setup as dfl' and minicom will start up with the correct settings next time. | |||
We shall not launch minicom immediately. We shall let Arduino IDE to finish uploading a sketch and then we can launch minicom. We can quit minicom by using Ctrl+A and z and x. | |||
Revision as of 19:49, 20 October 2013
Documentation
- Starting manual
- Mechanical Specs
- Schematics
- Pinout explained
Download
- SD Image and instruction to burn the image to microSD card; like
sudo umount /dev/sdc1 sudo dd bs=1M if=~/Downloads/udoo_dual_ubuntu_1.2.img of=/dev/sdc sudo sync sudo umount /media/<sd_label>
Arduino Programming
http://www.elinux.org/UDOO_programming_the_embedded_Arduino_microcontroller
From Udoo itself
I can use dmesg | grep ttymxc3 to double check the device is attached.
Simple LED sketch works well.
The Ethernet webServer sketch does not work. Why?
On an External computer
First I unplug J18 jumper, remove microSD card, and connect microUSB to CN6 in UDOO.
Download the official Arduino IDE 1.5.4.
I try to use dmesg | grep cp210x to check the device. The obstacle is the device is not found in Arduino IDE (No device found on ttyUSB0). If I try to follow 'Serial Driver' part to download and run 'make' , I will get an error
Linux_3.x.x_VCP_Driver_Source/cp210x.c:164:12: Error： 'usb_serial_probe' undeclared here (not in a function) Linux_3.x.x_VCP_Driver_Source/cp210x.c:165:16: Error : 'usb_serial_disconnect' undeclared here (not in a function)
Serial port monitor
On Linux, I can use minicom program to monitor serial port.
Use sudo minicom -s to configure minicom. Make sure the port is what we want. For example, /dev/ttyS0 when we use UDOO' ubuntu and dev/ttyUSB0 when we use external PC. The baud rate is set to 9600 8N1 and that 'Hardware flow control' is set to 'no'. Once we are done with the settings, use 'Save setup as dfl' and minicom will start up with the correct settings next time.
We shall not launch minicom immediately. We shall let Arduino IDE to finish uploading a sketch and then we can launch minicom. We can quit minicom by using Ctrl+A and z and x.